PCB Failure Analysis & Microsection

PCB Failure Analysis & Microsection

Quality & Inspection Standards

PRODUCTS CENTER

Get Custom Quote

PRODUCTS CENTER

Supported formats: PDF, DWG, Gerber, Excel (Max 50MB)
Submit

PCB Failure Analysis & Microsection

Cross‑sectioning (microsection) is the only way to see hidden defects inside a PCB — cracks, voids, delamination, and innerlayer separation that electrical test cannot detect. This hub covers IPC‑TM‑650 Method 2.1.1 and related failure analysis techniques used in high‑reliability, HDI, and aerospace boards.

Engineering Reality

We have seen Class 3 boards pass electrical test but fail microsection after thermal stress — exposing plating voids that would have caused field failures within months. Microsection is not a paperwork exercise; it is your only insurance against latent defects.

PCB Microsection Analysis

Complete guide to sample preparation, grinding, polishing, and micro‑etching per IPC‑TM‑650 2.1.1. Learn how to avoid artifacts that hide real failures.

Read More →

Copper Crack Identification

Type A‑F crack classification per IPC‑TM‑650 2.1.1. Type D (through‑hole separation) and Type B (innerlayer interface) are rejectable for Class 3.

Read More →

Plating Void Inspection

Wedge voids, pinholes, and micro‑voids in PTH and microvias. IPC‑6012E acceptance criteria: zero visible voids for Class 3.

Read More →

Delamination & Blister Analysis

Caused by moisture, poor lamination, or thermal shock. Microsection reveals separation at resin‑copper or prepreg‑core interfaces.

Read More →

Innerlayer Separation Defects

Often caused by oxide treatment failure or resin starvation. Detected after reduced etch time (IPC‑TM‑650 2.1.1 note 6.2).

Read More →

Microvia Failure Analysis

Target pad separation, corner cracks, and plating voids in HDI microvias. Failures often appear after reflow simulation (IPC‑TM‑650 2.4.13.1).

Read More →

Backdrill Stub Measurement

Measured via microsection perpendicular to the board plane. Residual copper or epoxy in backdrilled holes is non‑conforming for high‑speed designs (≥25 Gbps).

Read More →

PCB Cross Section Inspection Standards

Observable hole length ≥90% of drilled diameter. Minimum magnification: 100x for routine, 200x for arbitration.

Read More →

PCB Failure Photo Library

Reference images of copper cracks, plating voids, delamination, microvia failures, and backdrill stubs from real production cross‑sections.

Browse Library →

Microsection Quality Checklist

  1. Sample mounted perpendicular to polishing plane
  2. No air bubbles between sample and potting material (vacuum degassed)
  3. Rotate 90° between grinding steps; previous scratches fully removed (100x check)
  4. Final polish with 1µm diamond on low‑nap cloth, ≤30 seconds
  5. Micro‑etch with 50/50 NH₄OH / H₂O₂ for 3‑5 seconds only
  6. Observable hole length ≥90% of drilled diameter
  7. Measure minimum copper thickness and annular ring at 200x

Need expert review of your PCB microsections or failure analysis?

Request Engineering Review →

Get Custom Quote

PRODUCTS CENTER

Supported formats: PDF, DWG, Gerber, Excel (Max 50MB)
Submit