PCB & PCBA Frequently Asked Questions

PCB & PCBA Frequently Asked Questions

A centralized engineering knowledge base addressing common questions across PCB manufacturing, PCBA assembly, materials, processes, and reliability-driven design decisions.

PCBA Basics & Overview

What is the cost structure for low-volume PCBA?

Material cost 40-50%, processing (incl. depreciation) 30-40%, inspection 10-20%. Unit cost 30-50% higher than mass production

What is the ESD damage threshold for components?

CMOS devices have HBM sensitivity<2000V. Production environments must maintain<100V static voltage with wrist straps and ionizers.

What is the allowable range for PCB warpage?

IPC-A-600: ≤1.5%; BGA-assembled PCBs ≤0.7% to prevent dry joints.

How to evaluate solder joint mechanical strength?

0603 joints: minimum pull force ≥1.5N; QFP leads: shear force ≥5N, per IPC-9701.

What are the moisture absorption limits for PCBs under different conditions?

IPC-J-STD-033: MSL level 3 components ≤168 hours at 30℃/60%RH; bake at 125℃ for 4-8 hours if exceeded.

What is the open-circuit detection sensitivity of ICT?

High-precision ICT detects opens below 0.1Ω, with bed-of-nails contact resistance<100mΩ.

What is the minimum resolution of X-Ray inspection?

Micro-focus X-Ray achieves 5μm resolution, detecting 0.3mm pitch BGA joints and 20-layer PCB interiors.

What is the defect coverage rate of AOI inspection?

High-speed AOI covers ≥95% of 0402 component defects, >98% for QFP bridging/missing leads, but struggles with BGA internal voids.

What is the standard for ionic residue after cleaning?

IPC-TM-650: Ionic residue<1.5μg/cm² NaCl equivalent, surface insulation resistance>10⁹Ω.

What are the pros and cons of aqueous vs. solvent cleaning?

Aqueous: eco-friendly but requires high temperature (60-80℃), risk of corrosion; Solvent (e.g., NMP): efficient but needs explosion-proof equipment, VOC restrictions.

What temperature and airspeed settings for QFP rework with hot air guns?

Preheat 150-180℃, rework temperature 320-350℃, airspeed 4-6 (20-30L/min) to avoid lead deformation.

How to align and reball BGAs during rework?

Optical alignment systems (±25μm accuracy) with reballing fixtures ensure<0.1mm deviation between solder balls and pads.

Get Custom Quote

PRODUCTS CENTER

+86
  • +86 CN
Supported formats: PDF, DWG, Gerber, Excel (Max 50MB)
Submit