PCB & PCBA Frequently Asked Questions
A centralized engineering knowledge base addressing common questions across PCB manufacturing, PCBA assembly, materials, processes, and reliability-driven design decisions.
FAQ
PRODUCTS CENTER
Get Custom Quote
PRODUCTS CENTER
High-Frequency PCB FAQ
What are the key points for test fixture design of high-frequency PCB rigid boards?
Fixture contact impedance < 0.1Ω, insertion loss < 0.5dB; use SMA/K-type connectors covering the signal frequency band.
How to solve power supply noise interference in high-frequency PCBs?
Place MLCC combinations (10nF/100nF/1μF) at the power inlet; partition the power layer with ≥50mil spacing between voltage domains.
What is the impact of manufacturing tolerances on high-frequency PCB rigid board performance?
Line width tolerance ±0.02mm causes impedance 波动 ±3Ω; dielectric thickness tolerance ±0.01mm causes Dk deviation ±0.1, requiring strict control.
How to reduce dielectric loss in high-frequency PCBs?
Use PTFE-based low Df materials; optimize dielectric layer thickness to meet λ/4 resonance conditions and reduce energy loss.
How to control thermal stress in high-frequency PCB rigid boards?
Select materials with CTE ≤15ppm/℃, increase heat via density (≥20/cm²), and use metal-based copper-clad boards.
How to optimize high-frequency PCB design through simulation?
Use HFSS/CST for full-wave electromagnetic simulation to verify SI/PI; perform S-parameter sweep analysis at ≥10 frequency points.
How does PCB surface finishing affect high-frequency signals?
ENIG provides smooth surface and low loss; OSP's thin thickness suits high-frequency applications, avoiding magnetic loss from nickel layers.
What are the routing spacing requirements for differential signals on high-frequency PCBs?
Line spacing ≥3×line width, length error <5mil; embedded microstrip lines require distance to reference plane matching impedance calculations.
How to handle electromagnetic leakage in high-frequency PCBs?
Use metal shielding cans (shielding effectiveness ≥80dB) with gap width < λ/20; add ground via arrays at PCB edges.
What are the key parameters for multi-layer high-frequency PCB stack-up design?
Dielectric layer thickness 0.05-0.2mm, copper foil roughness Ra≤0.5μm; adjacent layer traces orthogonal, power/ground layer spacing < λ/20.
How to verify impedance matching for high-frequency PCBs?
Test S-parameters with a network analyzer, requiring S11 ≤ -15dB and characteristic impedance error ±5Ω; use TDR to observe reflection coefficient < 0.1.
How to select PCB materials for millimeter-wave frequency bands?
Prioritize low Dk (<3) and low Df (<0.005) materials, such as Rogers 4350B and Isola 370HR.
Get Custom Quote
PRODUCTS CENTER


