PCB & PCBA Frequently Asked Questions
A centralized engineering knowledge base addressing common questions across PCB manufacturing, PCBA assembly, materials, processes, and reliability-driven design decisions.
FAQ
PRODUCTS CENTER
Get Custom Quote
PRODUCTS CENTER
PCB Manufacturing FAQ
What is the manufacturing process?
Panelizing → Drilling → Copper deposition → Imaging → Plating → Etching → Solder mask → Silkscreen → Surface finish → Profiling.
What are the design software options?
Altium Designer (suitable for small-to-medium designs), Cadence Allegro (high-speed multi-layer), Mentor PADS (user-friendly and efficient).
What is the general design tolerance range?
Hole position: ±0.1mm. Plated vias: ±0.076mm. Non-plated vias: ±0.05mm. Line width: ±10%-20%.
How to address heat dissipation?
Thermal vias and copper planes under hot components. High thermal conductivity substrates. Airflow design; add heat sinks/fans if needed.
How to design the power layer?
Adjacent power and ground planes to reduce inductance. Voltage 分区 with via connections. Solid copper for power planes; thicken high-current paths.
What are the component layout principles?
Functional partitioning, separate heat-sensitive components, place high-frequency components close, prioritize large components, and ensure easy installation/maintenance.
How to reduce electromagnetic interference (EMI)?
Partition components; keep sensitive parts away from noise sources. Power/ground planes in multi-layer boards for shielding. Ground planes around high-speed signals. Decoupling capacitors; optimized grounding.
What is impedance matching and how to achieve it?
Matching source, transmission line, and load impedances to reduce reflection. Achieved by controlling line width, spacing, dielectric thickness, and permittivity (e.g., 0.33mm width for 50Ω microstrip on FR4).
What are the key points of via design?
Size based on thickness/current (thicker boards need larger vias). Minimize via count. Back-drilling for high-speed signals to remove stubs.
How to perform routing design?
Shorten signal traces, minimize vias. Use differential pairs for high-speed signals and control impedance. Power/ground planes with solid copper. Partition modules to avoid interference. Line width based on current.
What electrical factors should be considered in design?
Signal integrity (impedance matching, anti-reflection/crosstalk), power distribution, grounding, and current-carrying capacity.
How do new materials impact development?
Low-CTE materials improve dimensional stability. High thermal conductivity enhances heat dissipation. High-performance insulators reduce signal loss, enabling miniaturization and high performance.
Get Custom Quote
PRODUCTS CENTER


